dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Brakes - Premature Front Brake Pad Wear|Page 5115 > < Brakes - Premature Front Brake Pad Wear|Page 5109
Page 1
background image

Brake Pad: All Technical Service Bulletins
Brakes - Premature Front Brake Pad Wear

NUMBER: 05-003-11

GROUP: Brakes

DATE: February 18, 2011

SUBJECT:

Brake Front Pad Lining Life

OVERVIEW:
This bulletin involves installing new brake linings and replacing both brake rotors as required.

MODELS:

2009

(JC)

Journey

NOTE:

This Bulletin applies to vehicles built for the 2009 model year sold in U.S. and Canada (sales code YAA and YAC) markets only.

SYMPTOM/CONDITION:
Front brake pads may exhibit lining life complaints.

DIAGNOSIS:

1. Remove both front tire and wheel assemblies. Refer to the service information outlined in DealerCONNECT > TechCONNECT > Service

Information > 22 - Tires and Wheels > Removal

2. Using a Brake Lining Thickness Gauge or Brake Pad/Shoe Gauge, measure brake pad thickness.

3. Perform the repair procedure if the brake pad usable material measured at its thinnest point measures 4mm (0.1575 inches) or less.

4.

If the brake pad assemblies do not require replacement reassemble the vehicle. Refer to the service information outlined in DealerCONNECT >
TechCONNECT > Service Information tab > 22 - Tires and Wheels> Installation.

PARTS REQUIRED:

REPAIR PROCEDURE:

1. Remove the front brake pads. Refer to the service information outlined in DealerCONNECT > TechCONNECT > Service Information tab > 05 -

Brakes > 05 - Brakes, Base, Brake > Hydraulic/Mechanical > PADS, Brake, Front > Removal.

2. Remove any clips retaining the brake rotor to the wheel mounting studs.

3. Slide the brake rotor off the hub and bearing.

4. Clean the hub face to remove any dirt or corrosion where the rotor mounts.

5.

Perform Step  # 2 through Step # 4 on the opposite side of the vehicle.

6.

Install brake rotors (p/n CNM2X252AB) over the studs on the hub and bearing on both sides of the vehicle.

NOTE:

Rotor replacement is recommended when switching to this type brake pad. Standard brake service procedures apply thereafter.

7. Install new pads. Refer to the service information outlined in DealerCONNECT > TechCONNECT > Service Information tab > 05 - Brakes > O05 -

Brakes - Premature Front Brake Pad Wear|Page 5115 > < Brakes - Premature Front Brake Pad Wear|Page 5109