Journey FWD V6-3.5L (2009)
5. If equipped with a manual transaxle, remove the clamp and slide the clutch actuator hose (2) off the reservoir port (1).
6. Clean the area around where the master cylinder (2) attaches to the power brake booster (1) using a suitable brake cleaner such as Mopar(R) Brake
Parts Cleaner or an equivalent.
7. Remove the two nuts (3) attaching the master cylinder (2) to the power brake booster (1).
8. Slide the master cylinder straight out of the power brake booster.
Brake Master Cylinder - Installation
LEFT-HAND-DRIVE
NOTE: The master cylinder must be bled before installing it on the vehicle.
1. Bench bleed the master cylinder. See: Procedures
2. Wipe the face of the power brake booster clean where the vacuum seal on the rear of the master cylinder comes in contact when it's installed. Do
not get any cleaner or debris inside the booster.
