Journey FWD V6-3.5L (2009)
Hydraulic Control Assembly - Antilock Brakes: Removal and Replacement
Hydraulic Control unit (HCU) - Installation
INSTALLATION
To install the HCU, assemble and install the ICU. See: Overhaul/Integrated Control Unit (ICU) - Assembly See: Integrated Control Unit (ICU) -
Installation
Integrated Control Unit (ICU) - Removal
LEFT-HAND-DRIVE
NOTE: Before proceeding, See: Service Precautions/Technician Safety Information See: Service Precautions/Vehicle Damage Warnings .
NOTE: If servicing the ABM only, See: Antilock Brakes / Traction Control Systems/Electronic Brake Control Module/Service and
Repair/Anti-Lock Brake System Module - Removal
1. Disconnect and isolate battery negative cable from battery post.
2. Using a brake pedal holding tool as shown, depress the brake pedal past its first 25 mm (1 inch) of travel and hold it in this position. This will
isolate the master cylinder from the brake hydraulic system and will not allow the brake fluid to drain out of the master cylinder reservoir while the
lines are disconnected.
3. Remove the engine appearance cover.
4. Remove the two push-pins (1) securing the cowl top screen at the ends. Remove the remaining push-pins (2). Remove the cowl top screen (3).
5. Remove the wiper arms. See: Wiper and Washer Systems/Wiper Arm/Service and Repair/Wiper Arm - Removal
