Journey FWD V6-3.5L (2009)
14. Loosen, but do not remove, the two mounting screws (2) attaching the ICU (1) mounting bracket to the body.
15. Lift the ICU and mounting bracket (1) off the mounting screws (2).
16. Move the brake tubes around as necessary without bending them and remove the ICU with bracket.
NOTE: The HCU and the ABM are not serviceable separately from the ICU for vehicles equipped with Hill Start Assist (HSA).
17. To separate the ABM from the HCU, See: Overhaul/Integrated Control Unit (ICU) - Disassembly.
Integrated Control Unit (ICU) - Installation
LEFT-HAND-DRIVE
1. Install the ICU with bracket (1) through the opening between the A/C lines and the exhaust manifold using the opposite of how it was removed.
2. Place the mounting bracket for the ICU (1) over the mounting screws (2) and hang the assembly in place. Tighten the two mounting screws (2) to
23 Nm (17 ft. lbs.).
