Journey FWD V6-3.5L (2009)
2. Pull the parking brake cable strand (1) outward from the cable housing and hook it onto the caliper lever (2).
3. Push the excess cable strand back into the cable housing, then insert the cable housing (3) into the mounting bracket (1) until the retainer fingers
(2) lock into place. Make sure both fingers are engaged preventing removal of the cable from the bracket.
CAUTION: Before installing bolt (1) in the following step, it is especially important to clean the threads and apply Mopar(R) Lock & Seal
Adhesive or equivalent.
4. If servicing the left rear cable, position the cable routing clamps (3) against the axle trailing link and:
a. Install the upper mounting bolt (1) securing the trailing link (and cable routing clamp) to the knuckle. Tighten the mounting bolt to 60 Nm (44
ft. lbs.).
b. Install the bolt (2) attaching the other cable routing clamp to the axle trailing link. Tighten the bolt to 28 Nm (21 ft. lbs.).
CAUTION: Before installing bolt (1) in the following step, it is especially important to clean the threads and apply Mopar(R) Lock & Seal
