Journey FWD V6-3.5L (2009)
Adhesive or equivalent.
5. If servicing the right rear cable, position the cable routing clamps (3) against the axle trailing link and install the upper mounting bolt (1) securing
the trailing link (and cable routing clamp) to the knuckle. Tighten the mounting bolt to 60 Nm (44 ft. lbs.).
6. If servicing the right rear cable, route the cable over the rear axle (if equipped with AWD) along the front of the rear suspension crossmember.
Position the four routing clamps on the rear crossmember and install the screws. Tighten the screws to 6 Nm (55 in. lbs.).
.
7. If servicing the left rear cable, place the routing loop (3) over the studs on the vehicle underbody near the trailing link forward mounting point and
install the mounting nuts. Tighten the nuts to 6 Nm (55 in. lbs.).
8. Insert the right rear cable (2) through the lower loop of the cable routing loop (3).
