Journey FWD V6-3.5L (2009)
Muffler: Service and Repair
Installation
MUFFLER
NOTE: Always work from the front to rear of exhaust system when aligning and tightening exhaust system components.
1. Position muffler/resonator assembly (2) onto exhaust pipe.
2. Install support isolators.
3. Align muffler and resonator assembly to maintain position and proper clearance with underbody parts. All support isolators should have equal load
on them.
4. Install new band clamp (3). Tighten to 54 Nm (40 ft. lbs.).
5. Connect ground strap to muffler (2).
6. Lower vehicle.
7. Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.See: Testing and Inspection/Component Tests and General
Diagnostics
8. Check the exhaust system for contact with the body panels. Make the necessary adjustments, if needed.
