Journey FWD V6-3.5L (2009)
The rear blend door actuator cannot be adjusted or repaired and must be replaced if inoperative or damaged.
Front
DESCRIPTION
The mode door actuator (1) for the heating-A/C system is a reversible, 12-volt Direct Current (DC) servo motor, which is mechanically connected to the
mode-air doors. The mode door actuator is located on the right side of the HVAC air distribution housing.
The mode door actuator is contained within a black molded plastic housing with an integral wire connector receptacle (2). An output shaft with splines
(3) connect it to mode door linkage and integral mounting tabs (4) allow the actuator to be secured to the air distribution housing. The mode door
actuator does not require mechanical indexing to the mode-air doors, as it is electronically calibrated by the A/C-heater control.
The A/C-heater control must be recalibrated each time an actuator motor is replaced See: Testing and Inspection/Component Tests and General
Diagnostics/HVAC System Test.
The mode door actuator is interchangeable with the actuators for the recirculation and blend-air doors.
Rear
DESCRIPTION
The mode door actuator (1) for the rear heater-A/C system is a reversible, 12 volt direct current (DC), servo motor. The rear mode door actuator is
located on the outboard side of the rear heater-A/C housing.
The rear mode door actuator is contained within a black molded plastic housing with an integral wire connector receptacle (2), an output shaft with
splines (3) connect it to the rear mode-air door and three integral mounting tabs (4) allow the actuator to be secured to the rear heater-A/C housing. The
