Journey FWD V6-3.5L (2009)
1. Position the rear ceiling distribution duct (3) to the right D-pillar (2).
CAUTION: Use care when installing the rear ceiling distribution duct onto the heater-A/C housing to prevent damage to the molded plastic
support brace located on the top of the housing outlet. Failure to follow this caution could result in part of, or all of the support
brace falling into the rear housing, which may interfere with rear mode door operation.
2. Install the rear ceiling distribution duct onto the top of the rear heater-A/C housing (1). Make sure the duct is fully engaged to the housing.
3. Install the two retainers (4 and 5) that secure the rear ceiling distribution duct to the right D-pillar.
4. Position the upper seat belt bracket (2) onto the D-pillar (3) and install the two retaining bolts (1). Tighten the bolts to 52 Nm (38.5 ft. lbs.).
5. Install the right seat belt retractor (5) and retaining bolts (4) onto the D-pillar. Tighten the bolts to 52 Nm (38.5 ft. lbs.).
6. Install the right quarter trim panel See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage Compartment
Trim/Quarter Trim Panel - Installation.
7. Install the right D-pillar trim panel See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/D-Pillar
Trim/Installation
8. Reconnect the negative battery cable.
