Journey FWD V6-3.5L (2009)
Blower Motor Resistor: Testing and Inspection
Front Blower Motor Resistor
BLOWER MOTOR RESISTOR
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE: See Wiring Information for circuit descriptions and diagrams. Wiring Information includes wiring diagrams, proper wire and
connector repair procedures, further details on wire harness routing and retention, as well as pin-out and location views for the
various wire harness connectors, splices and grounds.
1. Disconnect and isolate the negative battery cable.
2. Disconnect the wire harness connector from the blower motor resistor .
3. Using an ohmmeter, check for continuity between all of the blower motor resistor terminals. In each case there should be continuity. If OK, repair
the wire harness circuits between the blower motor speed control and the blower motor resistor or blower motor as required. If not OK, replace the
inoperative blower motor resistor.
