Journey FWD V6-3.5L (2009)
Heater Core: Service and Repair
Rear Heater Core - Installation
INSTALLATION
CAUTION: To prevent damage to the plastic evaporator tube bracket, carefully guide the heater core tubes past the bracket during
installation of the heater core.
1. Carefully install the rear heater core (5) into the rear heater-A/C housing (4). Guide the heater core tubes past the plastic evaporator tube bracket
(2). Make sure that the foam seals are properly installed.
2. Install the screw (1) that secures the rear heater core tubes (3) to the outboard side of the rear heater-A/C housing. Tighten the screw to 1.2 Nm (10
in. lbs.).
3. Position the rear heater-A/C distribution housing (2) to the rear heater-A/C housing (5) and engage the five plastic retaining tabs (4). Make sure
the retaining tabs are fully engaged.
4. Install the three metal retaining clips (6) that secure the rear distribution housing to the rear heater-A/C housing.
5. Connect the wire harness connector (1) to the rear mode door actuator (3).
