dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

A/C Discharge Line - Removal|Page 7168 > < A/C Discharge Line - Removal|Page 7166
Page 2
background image

. Failure to properly adjust the refrigerant oil level will prevent the A/C system from operating as designed and can cause serious A/C
compressor damage.

NOTE: When replacing multiple A/C system components, refer to the Refrigerant Oil Capacities chart to determine how much oil should be

added to the refrigerant systemSee: Service and Repair/Refrigerant Oil Level .

NOTE: Replacement of the refrigerant line O-ring seals and gaskets is required anytime a refrigerant line is disconnected. Failure to replace

the rubber O-ring seals and metal gaskets could result in a refrigerant system leak.

NOTE: 2.7L shown. Other engines similar.

1. Remove the tape or plugs from the opened discharge line fittings and the compressor and condenser ports.
2. Lubricate new rubber O-ring seals with clean refrigerant oil and install them and new gaskets onto the discharge line fittings. Use only the

specified O-rings as they are made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C
compressor in the vehicle.

3. Position the A/C discharge line (1) into the engine compartment and connect it to the A/C compressor (2).
4. Install the nut (3) that secures the A/C discharge line to the A/C compressor. Tighten the nut to 20 Nm (15 ft. lbs.).

5. Connect the A/C discharge line (1) to the condenser tapping block (2).
6. Install the nut (5) that secures the A/C discharge line to the tapping block. Tighten the nut to 20 Nm (15 ft. lbs.).
7. Reconnect the negative battery cable.

CAUTION: Do NOT run the engine with a vacuum pump in operation or with a vacuum present within the A/C system when equipped with

the Denso 6SEU16 variable displacement compressor. Failure to follow this caution will result in serious A/C compressor damage.

8. Evacuate the refrigerant system See: Service and Repair/Refrigerant System Evacuate.
9. Adjust the refrigerant oil level See: Service and Repair/Refrigerant Oil Level.

10. Charge the refrigerant system See: Service and Repair/Refrigerant System Charge.

A/C Discharge Line - Removal|Page 7168 > < A/C Discharge Line - Removal|Page 7166