dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Removal and Replacement|Page 7200 > < Removal and Replacement|Page 7198
Page 8
background image

seals as they are made of special materials compatible to the R-134a system. Use only refrigerant oil of the type recommended for the A/C
compressor in the vehicle.

10. Connect the A/C liquid and suction line assembly (2) to the A/C expansion valve (3).
11. Install the nut (1) that secures the A/C liquid and suction line assembly to the A/C expansion valve. Tighten the nut to 20 Nm (15 ft. lbs.).

12. If equipped, position the heat shield (3) onto the studs (1) located on the dash panel in the engine compartment and install the retaining nuts (2).

Tighten the nuts to 1 Nm (10 in. lbs.).

13. Reconnect the negative battery cable.
14. If the heater core is being replaced, flush the cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
15. Refill the engine cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.

CAUTION: Do NOT run the engine with a vacuum pump in operation or with a vacuum present within the A/C system when equipped with

the Denso 6SEU16 variable displacement compressor. Failure to follow this caution will result in serious A/C compressor damage.

16. Evacuate and charge the refrigerant system See: Service and Repair/Refrigerant System Charge.
17. Initiate the Actuator Calibration function using a scan tool See: Testing and Inspection/Component Tests and General Diagnostics.

Rear HVAC Housing Removal

REMOVAL

WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service

Precautions/Warning  and See: Service Precautions/Caution . Failure to follow these instructions may result in serious or fatal injury.

NOTE: The rear heater-A/C housing must be removed from the vehicle for service of the mode door actuator and blend door actuator and it

must be disassembled for service of the A/C evaporator and the heater core.

1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Service and Repair/Refrigerant System Recovery.

Removal and Replacement|Page 7200 > < Removal and Replacement|Page 7198