Journey FWD V6-3.5L (2009)
The Denso 10SR15 and 10SR17 A/C compressors are filled with refrigerant oil from the factory. Use the following procedure to drain and measure
refrigerant oil from the Denso 10SR15 and 10SR17 A/C compressors.
1. Position the original A/C compressor so that the refrigerant oil can drain out of the suction and discharge ports into a suitable clean measured
container. Hold the original A/C compressor in this position until all of the refrigerant oil is drained from the compressor.
2. Drain all of the refrigerant oil from the replacement A/C compressor into a clean measured container.
3. Refill the replacement A/C compressor with the same amount of refrigerant oil that was drained out of the original compressor. Use only clean
refrigerant oil of the type recommended for the A/C compressor in the vehicle.
CAUTION: Failure to properly adjust the refrigerant oil level prior to installation of a replacement compressor can prevent the A/C system
from operating as designed and cause serious compressor damage.
See: Compressor HVAC/Service and Repair/A/C Compressor - Installation.
