Journey FWD V6-3.5L (2009)
Parking Brake Warning Switch: Service and Repair
Parking Brake Switch - Removal
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
FOOT-OPERATED
1. Disconnect and isolate the battery negative cable.
2. Apply the parking brake.
3. Reach under the left end of the instrument panel to access and disconnect the wire harness connector from the terminal of the park brake switch (2)
located on the park brake lever mechanism (1) on the left cowl side inner panel.
4. Remove the screw (3) that secures the park brake switch to the park brake lever mechanism.
5. Remove the switch from the park brake lever mechanism.
HAND-OPERATED
1. Disconnect and isolate the battery negative cable.
2. Remove the console from the floor panel transmission tunnel.See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Center
Console - Removal
