Journey FWD V6-3.5L (2009)
2. Install and tighten the screw (3) that secures the switch to the lever bracket. Tighten the screw to 2.5 Nm (24 in. lbs.).
3. Reconnect the wire harness connector to the terminal of the switch.
4. Reinstall the console onto the floor panel transmission tunnel.See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Center
Console - Installation
5. Reconnect the battery negative cable.
6. Turn the ignition switch to the ON position and check for proper brake indicator operation with the parking brake applied, then release the parking
brake and check that the brake indicator extinguishes.
