Journey FWD V6-3.5L (2009)
Oil Change Reminder Lamp: Technical Service Bulletins
Instruments - Vehicle Information Center Setup
NUMBER: 08-002-09
GROUP: Electrical
DATE: February 4, 2009
THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 08-014-07, DATED JULY 11, 2007, WHICH SHOULD BE REMOVED
FROM YOUR FILES. ALL REVISIONS ARE HIGHLIGHTED WITH **ASTERISKS** AND INCLUDES ADDITIONAL YEARS AND MODELS.
SUBJECT:
Electronic Vehicle Information Center (EVIC) Oil Change Indicator System - Dealer Preferences During Prep
MODELS:
2008
(DR)
Ram Truck
**2009
(HB)
Durango**
**2009
(HG)
Aspen**
**2009
(JC)
Journey**
**2008 - 2009
(KA)
Nitro**
**2008 - 2009
(KK)
Liberty**
**2009
(LC)
Challenger**
**2008 - 2009
(LX)
300 / Magnum / Charger**
**2008 - 2009
(RI)
Caravan / Town & Country**
NOTE:
This Bulletin applies to vehicles equipped with a programmable EVIC.
DISCUSSION:
**Many models now include an oil change indicator system**. This system displays an "Oil Change Required" or "Oil Change" message at appropriate
intervals on the instrument cluster.
The vehicles listed above may be equipped with a programmable display on the Electronic Vehicle Information Center, (EVIC). The "Oil Change
Required message may also include the dealerships name and phone number which can be programmed into the vehicle with the StarSCAN(R) or
StarMOBILE(R) scan tool.
NOTE:
**Other vehicles may be added at any time. Dealers can determine if the feature is available by following the procedures below. If Enable/Disable
Dealer Contact Information is active, the feature can be used to enter the servicing dealer's information.**
The following procedure describes the steps to add, delete or change a dealership name and phone number on the display.
NOTE:
If NOT programmed during vehicle prep, customer approval MUST be obtained before adding or changing this information.
NOTE:
When performing this Procedure, the software release level in the StarSCAN(R) or StarMOBILE(R); must be programmed with the latest level
software. The software release level is visible in the blue header at the top of the StarSCAN(R) or StarMOBILE(R) screen.
1.
Connect the StarSCAN(R) or StarMOBILE(R). (in Pass-Through Mode)
NOTE:
To use the StarMOBILE(R) in Pass-Through Mode requires that StarMOBILE(R) be connected to the dealership network via a wired or wireless
connection. For more information on how to use the StarMOBILE(R) in Pass-Through Mode, see the StarMOBILE(R) training tutorials available on
DealerCONNECT > Service > Repair > StarSCAN(R) and StarMOBILE(R) Tools link or at the website.
