Journey FWD V6-3.5L (2009)
1. Turn the ignition off.
WARNING: The fuel system is under a constant pressure (even with the engine off). Before testing or servicing any fuel system hose, fitting or
line, the fuel system pressure must be released. Failure to follow these instructions can result in possible serious or fatal injury.
2. Remove the Fuel Pump Module and Fuel Tank Module (if equipped), inspect the Fuel Inlet and the bottom of the fuel tank for debris that could
cause the fuel pump inlet to be plugged.
Is the Fuel Pump Inlet plugged?
Yes
-
Repair/Replace as necessary.
-
Perform the PCM Verification TestSee: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests/PCM Verification Test
No
-
Replace the Fuel Pump Module.
-
Perform the PCM Verification TestSee: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests/PCM Verification Test
7. FUEL PUMP MOTOR GROUND CIRCUIT
1. Turn the ignition off.
2. Disconnect the Fuel Pump Module harness connector.
3. Using a 12-volt test light to battery voltage, probe the Fuel Pump Motor Ground circuit in the Fuel Pump Module harness connector.
NOTE: The test light should be illuminated and bright. Compare the brightness to that of a direct connection to the battery.
Does the test light illuminate brightly.
Yes
-
Replace the Fuel Pump Module.
-
Perform the PCM Verification TestSee: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests/PCM Verification Test
No
-
Repair the Fuel Pump Motor Ground circuit.
-
Perform the PCM Verification TestSee: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests/PCM Verification Test
