Journey FWD V6-3.5L (2009)
6. Adjust air pressure to that listed on Tire Inflation Pressure Label (Placard) provided with vehicle (applied to driver's side B-pillar). Make sure
original style and color valve stem cap is securely installed to keep moisture out of sensor.
7. Install tire and wheel assembly (1) on vehicle See: Service and Repair/Removal and Replacement/Tires and Wheels - Installation. Tighten wheel
mounting nuts (3) to 135 Nm (100 ft. lbs.).
8. Lower vehicle.
9. Perform one of the following to make the system learn the new sensor ID.
a. Use the TPM-RKE Analyzer, Special Tool 9936, with the Scan Tool to program the WIN with the tire pressure sensor ID. This is part of the
TPM Diagnostic Verification Test, See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests/Vehicle Theft Security Verification Tests/Tire Pressure Monitor (TPM) Verification
Test.
b. Once the vehicle has remained stationary for more than 20 minutes, drive vehicle for a minimum of 10 minutes while maintaining a continuous
speed above 15 mph (24 km/h). During this time, the system will learn the new sensor ID. This is part of the TPM Diagnostic Verification
Test, See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/Verification Tests/Vehicle Theft Security Verification Tests/Tire Pressure Monitor (TPM) Verification Test.
NOTE: If a sensor cannot be trained, refer to appropriate diagnostic information.
