Journey FWD V6-3.5L (2009)
Fuse: Service and Repair
IOD Fuse - Removal
REMOVAL
NOTE: When removing or installing the Ignition Off Draw (IOD) fuse, it is important that the ignition switch be in the OFF position. Failure
to place the ignition switch in the OFF position can cause the radio display to become scrambled when the IOD fuse is installed.
Removing and installing the IOD fuse again with the ignition switch in the OFF position will usually correct the scrambled radio
display condition.
1. Turn the ignition switch to the OFF position.
2. Remove the cover from the Totally Integrated Power Module (TIPM).
3. Pull on IOD fuse (J13) holder until it reaches the first detent.