Journey FWD V6-3.5L (2009)
2.
Inspect the engine wiring harness and, if equipped, the 120 volt engine block heater cord at the left transaxle mount for chafed wires (Figure 1):
>
If wire chafing is not found, continue with Step 6 of this procedure.
>
If wire chafing is found, continue with Step 3 of this procedure.
3.
Remove the wiring harness protective tape from around the damaged area.
4.
Repair wire(s) as required.
5.
Install electrical tape around repaired area of wiring harness.
6.
Disconnect the 14-way connector using the following procedure:
