Journey FWD V6-3.5L (2009)
TECH TIPS and INFORMATION:
CAUTION: Extreme care must be taken when programming a calibration into a generic PCM. Do not randomly select a calibration. Once a
calibration is selected and programmed, the controller cannot be reprogrammed to a different calibration. The module can only be
reprogrammed to a more recent version of that calibration.
1. The wiTECH(TM) Diagnostic Application is the preferred method for flashing any Chrysler vehicle ECU. For more information, training tutorials
are available under the "HELP" tab in the wiTECH(TM) Diagnostic Application, under the 'Training Aids' link.
2. To use the StarMOBILE(R) in Pass-Through Mode requires that your StarMOBILE(R) is connected to the dealerships network via a wired or
wireless connection. For more information on how to use the StarMOBILE in Pass-Through Mode see the StarMOBILE(R) training tutorials
available on 'DealerCONNECT > Service > StarSCAN(R) and StarMOBILE(R) Tools > Training Aids', under the 'Training Aids' link.
3. If the flash process is interrupted or aborted, the flash should be restarted.
4. Due to the PCM/ECM / TCM programming procedure, a DTC may be set in other ECUs within the vehicle. Some DTCs may cause the MIL to
illuminate. From the "Home" screen select "System View". Then select "All DTCs". Press "Clear All Stored DTCs" if there are any DTCs shown
on the list.
5. Do not allow the battery charger to time out or the charging rate to climb above 13.5 Volts during the flash process.
6. The StarSCAN(R) and StarMOBILE(R) diagnostic tools fully support Internet connectivity and must be configured for your dealership's network.
For help on setting up your StarSCAN(R) / StarMOBILE(R) for the dealership's network, refer to the StarSCAN(R) / StarMOBILE(R) Quick Start
Networking Guide available on 'DealerCONNECT > Service > StarSCAN(R) and StarMOBILE(R) Tools > Online Documentation', under the
download center.
7. The operating software in the StarSCAN(R) and StarMOBILE(R) must be programmed with the latest software release level. The software level is
visible in the blue header at the top of the StarSCAN(R) and StarMOBILE(R) Desktop Client screens. For instructions on how to update your scan
tool, refer to the StarSCAN(R) / StarMOBILE(R) Software Update guide available on 'DealerCONNECT > Service > StarSCAN(R) and
StarMOBILE(R) Tools > Online Documentation', under the download center.
PARTS REQUIRED
Module/Programming Order Replacement Guide
MODULE/PROGRAMMING ORDER REPLACEMENT GUIDE
Module Programming
