Journey FWD V6-3.5L (2009)
-
Turn the ignition off.
-
Disconnect, empty and then reconnect the Reservoir Assembly.
1. Turn the ignition on, wait five seconds, turn the ignition off and then wait one minute before proceeding.
2. Read the Fuel Pressure Gauge (3) and record the reading. Non SRT-4 fuel pressure specification is 407 kPa ± 34 kPa (59 psi ± 5 psi). SRT-4 fuel
pressure specification is 552 kPa ± 34 kPa (80 psi ± 5 psi).
Is the fuel pressure within specifications?
Yes
-
Go To 5
No
-
Perform the CHECKING THE FUEL DELIVERY SYSTEM diagnostic procedure. See: Computers and Control Systems/Testing and
Inspection/Component Tests and General Diagnostics/Checking the Fuel Delivery System
5. CHECK FUEL DELIVERY SYSTEM OUTPUT
WARNING: The fuel system is under a constant pressure (even with the engine off). Before testing or servicing any fuel system hose, fitting, or
line, the fuel system pressure must be released. Failure to follow these instructions can result in possible serious or fatal injury.
1. Ignition on, engine not running.
2. With the scan tool, actuate the fuel pump.
3. Open the Flow Test Valve (1) for 20 seconds, then close the Valve.
CAUTION: Stop All Actuations.
4. Turn the ignition off.
5. Measure the amount of fuel in the Reservoir Assembly (2). The fuel output specification is ml/s X 20 seconds = fuel flow in ml.
Does the amount of fuel in the reservoir meet or exceed the specification?
Yes
-
Test complete.
No
-
Perform the CHECKING THE FUEL DELIVERY SYSTEM diagnostic procedure. See: Computers and Control Systems/Testing and
Inspection/Component Tests and General Diagnostics/Checking the Fuel Delivery System
