Journey FWD V6-3.5L (2009)
6.
Disconnect both PCM electrical connectors (Figure 2).
7.
Remove the two PCM mounting bracket retaining nuts and remove the PCM and mounting bracket as an assembly (Figure 2).
8.
Remove the four mounting screws that hold the PCM to the mounting bracket.
9.
Install the new PCM on to the mounting bracket.
10.
Install the four PCM-to-mounting bracket retaining screws. Tighten the screws to 95 lbs. in. (11 N.m) (Figure 2).
11.
Install the PCM and bracket into the vehicle. Tighten the two mounting nuts to 95 in. lbs. (11 N.m).
12.
Connect both PCM electrical connectors (Figure 2).
13.
Connect the negative battery cable.
14.
Continue with Section C. Program PCM.
C. Program PCM
NOTE:
Either StarSCAN or StarMOBILE can be used to perform this recall. This procedure must be performed with the latest software release level.
If the reprogramming flash for the PCM is aborted or interrupted, repeat the procedure.
PCM Programming Procedure using StarSCAN
1.
Open the hood. Install a battery charger and verify that the charging rate provides 13.0 to 13.5 volts. Do not allow the charger to time out during
the flash process. Set the battery charger timer (if so equipped) to continuous charge.
NOTE:
Use an accurate stand alone voltmeter. The battery charger voltmeter may not be sufficiently accurate. Voltages outside of the specified range
will cause an unsuccessful flash. If voltage reading is too high, apply an electrical load by activating the park or headlamps and/or HVAC
blower motor to lower the voltage.
2.
Connect the CH9410 StarSCAN ethernet cable to the StarSCAN and the dealer's network drop.
3.
Connect the CH9404 StarSCAN vehicle cable to the StarSCAN and the vehicle.
4.
Place the Ignition in the "RUN" position, then Power "ON" the StarSCAN.
5.
Download the flash file from the internet to the StarSCAN. With the StarSCAN on the "Home" screen, follow the procedure below:
a.
Select "ECU View"
b.
Touch the screen to highlight "PCM" in the list of modules.
