Journey FWD V6-3.5L (2009)
NOTE:
Use an accurate stand alone voltmeter. The battery charger voltmeter may not be sufficiently accurate. Voltages outside of the specified range
will cause an unsuccessful flash. If voltage reading is too high, apply an electrical load by activating the park or headlamps and/or HVAC
blower motor to lower the voltage.
2.
Determine the PCM software part number using the following procedure:
Using StarSCAN:
a.
Connect the CH9404 StarSCAN vehicle cable to the StarSCAN and the vehicle.
b.
Place the Ignition in the "RUN" position, then Power "ON" the StarSCAN.
c.
Starting at the "Home" screen select "ECU View".
d.
Touch the screen to highlight "PCM" in the list of modules.
e.
Select "More Options".
f.
Select "ECU Flash".
g.
Record the part number at the top of the Flash PCM screen for later reference.
Using StarMOBILE:
a.
Connect the CH9410 StarMOBILE ethernet cable to the StarMOBILE and the dealer's network drop.
b.
Connect the CH9404 StarMOBILE vehicle cable to the StarMOBILE and the vehicle.
c.
Place the Ignition in the "RUN" position, then Power "ON" the StarMOBILE.
d.
Record the StarMOBILE I.P. address displayed on the StarMOBILE screen.
e.
From the desktop, launch the "StarMOBILE Desktop Client" software.
f.
Establish a connection with the StarMOBILE scan tool.
g.
Starting at the "Home" screen select "ECU View".
h.
Touch the screen to highlight "PCM" in the list of modules.
i.
Select "More Options".
j.
Select "ECU Flash".
k.
Record the part number at the top of the Flash PCM screen for later reference.
3.
Place the Ignition in the "OFF" position.
4.
Disconnect and remove the battery charger.
5.
Disconnect the negative battery cable.
