Journey FWD V6-3.5L (2009)
b.
Select "PCM".
c.
Select "Misc. Functions".
d.
Select "Check PCM VIN" and follow the on screen instructions.
e.
When complete, select "Finish".
9.
Perform the learn Electronic Throttle Control (ETC) programming using the following procedure:
a.
From the "Home" screen, select "ECU View".
b.
Select "PCM".
c.
Select "Misc. Functions".
d.
Select "Learn ETC" and press the "Start" button on the StarSCAN screen.
e.
Follow the screen prompts to complete the process.
10.
Check the PCM Odometer programming using the following procedure:
a.
From the "Home" screen, select "ECU View".
b.
Select "PCM".
c.
Select "Misc. Functions".
d.
Select "Check PCM Odometer" and press the "Start" button on the StarSCAN.
e.
Follow the on screen instructions.
f.
When complete, select "Finish".
11.
Place the Ignition in the "OFF" position, then Power "Off" the StarSCAN.
12.
Disconnect the Data Link Connector (DLC), wait 15 seconds, and reconnect the DLC to the vehicle.
13.
Place the ignition in the "RUN" position and then Power "ON" the StarSCAN.
14.
Vehicles equipped with a four-speed transaxle, perform Transmission Control Module (TCM) Quicklearn programming using the following
procedure:
a.
From the "Home" screen, select "ECU View".
b.
Select "TCM".
c.
Select "Misc. Functions".
d.
Select "Quicklearn" and press the "Start" button on the StarSCAN.
e.
Follow the on screen instructions.
f.
When complete, select "Finish".
15.
Clear any Diagnostic Trouble Codes (DTCs) as follows:
NOTE:
Due to the PCM programming procedure, DTC(s) may be set in other modules (TCM, ABS, BCM, MIC, WCM, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate.
a.
From the "Home" screen select "System View".
b.
Select "All DTCs".
