Journey FWD V6-3.5L (2009)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System Module - Removal
LEFT-HAND DRIVE
NOTE: The ABM is only separately serviceable for non-HSA (Hill Start Assist) equipped vehicles. Do not remove the ABM for vehicles
equipped with HSA.
1. Disconnect the negative (ground) cable from the battery and isolate it.
2. Remove the engine appearance cover.
3. Remove the two push-pins (1) securing the cowl top screen at the ends. Remove the remaining push-pins (2). Remove the cowl top screen (3).
4. Remove the wiper arms. See: Wiper and Washer Systems/Wiper Arm/Service and Repair/Wiper Arm - Removal
5. Remove the push-pins (1) securing the cowl screen to the wheelhouse brace and cowl. Rotate the screw (2) in the center of the cowl screen 90°
clockwise to release the screen. Remove the cowl screen (3).
