Journey FWD V6-3.5L (2009)
NOTE: Use this figure in the following step to release the ABM harness connector cover. It shows the location of the release tabs.
14. Disconnect the ABM harness connector from the Antilock Brake Module (ABM). To do so:
a. Depress the tabs on each side of the connector cover, then
b. Pull outward and upward on the lower half of the cover until it locks into position pointing straight outward (2). The connector can then be
pulled straight outward off the ABM (1).
15. Remove the four screws (1) attaching the ABM (2) to the HCU. A Torx T20 bit approximately 2 inches long works well.
