Journey FWD V6-3.5L (2009)
6. Pull the side impact sensor straight out from the mounting location to unsnap the anti-rotation pin on the base of the sensor from the clearance hole
in the lower C-pillar.
7. Remove the side impact sensor from the vehicle.
Side - Third Row Seating
SIDE - THIRD ROW SEATING
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
WARNING: To avoid serious or fatal injury, never strike or drop the side impact sensor, as it can damage the impact sensor or affect its
calibration. The side impact sensor enables the system to deploy the side Supplemental Restraint System (SRS) components. If an
impact sensor is accidentally dropped during service, the sensor must be scrapped and replaced with a new unit. Failure to
observe this warning could result in accidental, incomplete, or improper side SRS component deployment.
NOTE: The front and the second or third row seating side impact sensors are interchangeable.
1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
2. Remove the quarter trim panel from the quarter inner panel over the rear wheel housing (1). See: Body and Frame/Interior Moulding / Trim/Trim
Panel/Service and Repair/Luggage Compartment Trim/Quarter Trim Panel - Removal.
3. Disconnect the body wire harness connector (2) from the side impact sensor (4) above the rear wheel housing on the quarter inner panel.
4. Remove the screw (3) that secures the side impact sensor to the quarter inner panel.
5. Pull the side impact sensor straight out from the mounting location to disengage the anti-rotation pin on the base of the sensor from the clearance
hole in the quarter inner panel.
6. Remove the side impact sensor from the vehicle.