Journey FWD V6-3.5L (2009)
9. Remove the second row outboard seat belt and retractor from the vehicle as a unit.
Third Row Seat Belt and Retractor
THIRD ROW SEAT BELT AND RETRACTOR
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
1. Remove the third row seat cushion and cover from the rear floor panel See: Body and Frame/Seats/Seat Cover/Service and Repair/Seat Cushion
Cover - Removal.
2. Remove the screw (2) that secures the third row seat belt lower anchor (1) and the third row seat back (3) outboard bracket to the rear floor panel.
3. Remove the lower anchor from the third row seat back outboard bracket.
4. Unsnap and remove the trim cover (1) from the third row seat belt turning loop on the inside of the upper D-pillar trim (3) to access the turning
loop screw (2).
5. Remove the screw (2) that secures the seat belt turning loop to the bracket on the inside of the upper D-pillar.
6. Remove the turning loop from the D-pillar.
7. Remove the trim from the inside of the upper D-pillar See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/D-Pillar Trim/Removal.
8. Loosen the rear of the quarter trim panel from the lower D-pillar enough to access the third row outboard seat belt and retractor (7) See: Body and
Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage Compartment Trim/Quarter Trim Panel - Removal.
9. Remove the screw (4) that secures the upper retractor bracket to the inside of the D-pillar.
