Journey FWD V6-3.5L (2009)
Trim/D-Pillar Trim/Installation.
7. Position the seat belt turning loop to the inside of the upper D-pillar. Be certain the seat belt webbing (5) is not twisted between the retractor and
the turning loop.
8. Install and tighten the screw (2) that secures the turning loop to the bracket on the inside of the upper D-pillar. Tighten the screw to 43 Nm (32 ft.
lbs.).
9. Snap the trim cover (1) over the seat belt turning loop on the inside of the upper D-pillar.
10. Position the seat belt lower anchor (1) to the third row seat back (3) outboard bracket on the rear floor panel. Be certain the seat belt webbing is
not twisted between the turning loop and the lower anchor.
11. Install and tighten the screw (2) that secures the lower anchor and the third row seat back outboard bracket to the rear floor panel. Tighten the
screw to 90 Nm (66 ft. lbs.).
12. Reinstall the third row seat cushion and cover to the rear floor panel See: Body and Frame/Seats/Seat Cover/Service and Repair/Seat Cushion
Cover - Installation.
