Journey FWD V6-3.5L (2009)
Washer Fluid Level Switch: Service and Repair
Washer Fluid Level Switch - Installation
INSTALLATION
1. Install a new rubber grommet seal into the washer fluid level switch mounting hole of the washer reservoir. Always use a new rubber grommet seal
on the reservoir.
2. Insert the nipple formation of the switch through the rubber grommet seal in the reservoir.
3. Using hand pressure, press firmly and evenly on the switch mounting flange until the barbed nipple is fully seated in the rubber grommet seal in
the reservoir. The flat edge of the switch mounting flange should be oriented upward.
4. Reconnect the Front End Module (FEM) wire harness connector (3) to the switch connector receptacle.
5. Reinstall the washer reservoir onto the back of the cooling module on the FEM. See: Wiper and Washer Systems/Windshield Washer
Reservoir/Service and Repair/Windshield Washer Reservoir - Installation.
6. Reconnect the battery negative cable.
