Journey FWD V6-3.5L (2009)
cable to the positive battery post (2). Connect the other end of the same cable to the positive terminal of the booster battery.
5. Connect the other cable, first to the negative terminal of the booster battery and then to the engine ground (-) of the vehicle with the discharged
battery (5). Make sure you have a good contact on the engine ground.
6. If the vehicle is equipped with Sentry Key Immobilizer, turn the ignition switch to the ON position for three seconds before moving the ignition
switch to the START position.
7. Start the engine in the vehicle that has the booster battery, let the engine idle a few minutes, and then start the engine in the vehicle with the
discharged battery.
8. When removing the jumper cables, reverse the sequence exactly. Be careful of the moving belts and fan.
9. Reinstall the protective cover over the remote jump-start positive battery post.
WARNING: During cold weather when temperatures are below freezing point, electrolyte in a discharged battery may freeze. Do not attempt
jump-starting because the battery could rupture or explode. The battery temperature must be brought up above freezing point
before attempting jump-start.
WARNING: Any procedure other than above could result in:
-
Personal injury caused by electrolyte squirting out the battery vent;
-
Personal injury or property damage due to battery explosion;
-
Damage to charging system of booster vehicle or of immobilized vehicle.
