Journey FWD V6-3.5L (2009)
Connector, Ground and Splice Information
CONNECTOR, GROUND AND SPLICE INFORMATION
CAUTION: Not all connectors are serviced. Some connectors are serviced only with a harness. A typical example might be the Supplemental
Restraint System connectors. Always check parts availability before attempting a repair.
IDENTIFICATION
In-line connectors are identified by a number, as follows:
-
In-line connectors located in the engine compartment are C100 series numbers.
-
In-line connectors located in the instrument panel area are C200 series numbers.
-
In-line connectors located in the body are C300 series numbers.
-
Jumper harness connectors are C400 series numbers.
-
Grounds and ground connectors are identified with a "G" and follow the same series numbering as the in-line connectors.
-
Splices are identified with an "S" and follow the same series numbering as the in-line connectors. In addition, S001-S099 numbers are located in
the engine compartment.
-
Component connectors are identified by the component name instead of a number. Multiple connectors on a component use a C1, C2, etc.
identifier.
LOCATIONS
Section 8W-91 contains connector/ground/splice location illustrations. The illustrations contain the connector name (or number)/ground number/splice
number and component identification. Connector/ground/splice location charts in section 8W-91 reference the figure numbers of the illustrations.
The abbreviation T/O is used in the component location section to indicate a point in which the wiring harness branches out to a component. The
abbreviation N/S means Not Shown in the illustrations
Section Identification and Information
