Journey FWD V6-3.5L (2009)
5. Move the steering column to the fully lowered position.
6. Remove the three screws that secure the Steering Column Control Module to the steering column bracket.
7. Pull the Steering Column Control Module away from the steering column far enough to access and disconnect the three instrument panel wire
harness connectors from the receptacles on the back of the Steering Column Control Module case.
8. Remove the Steering Column Control Module from the steering column.
9. Transfer the right multi-function switch from the old Steering Column Control Module to the new Steering Column Control Module (Figure 7).
10. Transfer the left multi-function switch from the old Steering Column Control Module to the new Steering Column Control Module (Figure 8).
11. Transfer the multi-function switch jumper harness from the old Steering Column Control Module onto the new Steering Column Control Module
(Figure 8).
CAUTION:
Make sure that the jumper wire connectors are locked in place by gently pulling on them.
12. Carefully slide the Steering Column Control Module down over the steering column upper shaft far enough to reconnect the three instrument
panel wire harness connectors to the receptacles on the back of the Steering Column Control Module case.
13. Position the Steering Column Control Module onto the steering column bracket.
14. Install and tighten the three screws that secure the Steering Column Control Module to the steering column bracket to 27 in. lbs. (3 N.m) in the
