Journey FWD V6-3.5L (2009)
following sequence:
>
Lower right screw
>
Upper left screw
>
Upper right screw
CAUTION:
Use of an improper sequence when tightening the Steering Column Control Module mounting screws may result in an audible ticking noise as the
steering wheel is rotated.
15. Install the upper and lower shrouds onto the steering column.
16 Install the knee bolster.
17. Move the steering column back to the fully raised position and move the tilt release lever to the locked position.
18. Install the steering wheel onto the steering column.
19. Install the steering wheel retaining bolt and tighten bolt to 45 ft. lbs. (61 N.m).
20. Remove the plastic locking pin that secures the clockspring rotor to the Steering Column Control Module case.
21. Connect the white steering wheel wiring connector.
22. Connect the squib connectors to the driver airbag module.
23. Install the driver airbag module to the steering wheel.
24. Perform the Supplemental Restraints Verification Test below:
a. Connect the scan tool to the 16-way data link connector located on the driver's side lower edge of the instrument panel.
b. Turn the ignition switch to the "ON" position and exit the vehicle with the scan tool.
c. Check and make certain that nobody is in the vehicle, then reconnect the negative battery cable.
d. Using the scan tool, read and record active and historical Diagnostic Trouble Codes (DTC's).
e. Use the scan tool to erase the stored DTC's.
f.
Turn the ignition to the "OFF" position for about 15 seconds, and then back to the "ON" position. Observe the airbag indicator lamp in the
instrument cluster. It should light for six to eight seconds and then go out. This indicates that the SRS is functioning normally and that the
repairs are complete.
g. Remove the scan tool from the vehicle.
h. Return the vehicle to the customer.
