Journey FWD V6-3.5L (2009)
3. As necessary (see above note), place a stack of washers approximately 13 mm (0.5 in.) thickness (3) over Spacer 6936 (2).
NOTE: It is important to use Forcing Screw C-4063-2 when performing this procedure.
4. Thread Installer C-4063C (1), completely into internal threads of power steering pump shaft, then rotate Installer Nut down against washers (as
necessary) and Spacer (2) on pump pulley.
5. Ensuring that the tools and pulley remain aligned with pump shaft, tighten Installer Nut, forcing pulley onto power steering pump shaft until
Spacer (2) comes in contact with end of pump shaft. When Spacer (2) is against shaft of power steering pump, Installer (1) Nut will no longer
rotate.
6. Install power steering pump on engine.See: Power Steering Pump - Installation.
