Journey FWD V6-3.5L (2009)
7. Return the vehicle to the customer.
B. Inspect Steering Column Control Module Wiring Orientation
WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting Steering
Column Control Module replacement. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor
to discharge before proceeding. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
1. Disconnect and isolate the negative battery cable, then wait two minutes before proceeding.
2. Place the steering wheel in the straight ahead position.
NOTE:
The front wheels must also be in the straight ahead position.
3. Separate the driver airbag module from the steering wheel but do not disconnect the driver airbag module squib wires.
CAUTION:
Do not allow the driver airbag module to hang by the squib wires.
NOTE:
Some models use three clips to hold the driver airbag module to the steering wheel (Figure 4).
4. Remove the black electrical tape that holds the two sets of squib wires together (Figure 5).
