Journey FWD V6-3.5L (2009)
5. Inspect the driver airbag module squib wiring orientation going into the Steering Column Control Module (Figure 6):
>
If the pair of red and blue wires going into the Steering Column Control Module enter on the left side and the pair of yellow and brown wires
enter on the right side, the Steering Column Control Module does not require repair. Continue with Step 6 of this procedure.
>
If the pair of red and blue wires going into the Steering Column Control Module enter on the right side and the pair of yellow and brown
wires enter on the left side, the Steering Column Control Module is defective and must be replaced. Continue with Section C. Replace
Steering Column Control Module.
6. Install the driver airbag module onto the steering wheel.
7. Install the steering column cover shrouds.
8. Install the knee bolster.
9. Connect the negative battery cable.
10. Return the vehicle to the customer.
C. Replace Steering Column Control Module
CAUTION:
The clockspring in the Steering Column Control Module is shipped with the clockspring pre-centered and with a molded plastic locking pin
installed. This locking pin must not be removed until the steering wheel has been installed on the steering column (Step 20).
1. Disconnect the driver airbag module wires and place the module aside.
2. Disconnect the white steering wheel wiring connector.
3. Remove the steering wheel retaining bolt.
4. Remove the steering wheel from the steering shaft.
