Journey FWD V6-3.5L (2009)
2. Unsnap the knee bolster at the top of the bolster and allow it to hinge downward (Figure 2).
3. Remove the upper and lower plastic steering column shrouds.
4. Inspect the first four digits of the Julian data code (disregard the fifth digit) on the label located on the bottom of the Steering Column Control
Module (Figure 3) for the following:
>
If the Julian date code on the bar code data label is 0409, 0419, or 0429 continue with Section B. Inspect Steering Column Control Module
Wiring Orientation.
>
If the Julian date code on the bar code data label is not 0409, 0419, or 0429 the Steering Column Control Module does not require further
inspection or replacement. Continue with Step 5 of this procedure.
5. Install the steering column cover shrouds.
6. Install the knee bolster.
