Journey FWD V6-3.5L (2009)
14. Remove the screws (1) securing the power steering hose routing clamps (2) to the rear of the crossmember.
15. Unscrew the tube nut (2), then remove the return hose (1) at the steering gear.
16. Unscrew the tube nut (3), then remove the pressure hose (4) at the steering gear.
NOTE: Before lowering the front suspension crossmember, the location of the crossmember must be marked on the body of the vehicle. Do
this so the crossmember can be relocated, upon reinstallation, against the body of vehicle in the same location as before removal. If the
front suspension crossmember is not reinstalled in exactly the same location as before removal, the preset front wheel alignment
settings (caster and camber) may be lost.
17. Using a crayon or marker (2) that will not break the paint surface, mark the location of the front crossmember (1) on the body near each mounting
bolt. Do not use any type of sharp instrument that will damage the underbody of the vehicle.
