Journey FWD V6-3.5L (2009)
8. Slowly raise the crossmember (9) into mounted position using the transmission jack matching the crossmember to the marked locations on the
body made during removal.
9. Position the front crossmember reinforcement brackets (7) (one each side of vehicle) over the crossmember rear mounting bushings and install the
mounting screws (8), but do not tighten at this time.
10. Install the four mounting bolts (6) securing the front crossmember (1) to the body. Tighten the crossmember mounting bolts to 135 Nm (100 ft.
lbs.).
11. Tighten the crossmember reinforcement bracket mounting screws (8) to 50 Nm (37 ft. lbs.).
12. Remove the transmission jack.
13. Install the pressure hose tube (4) at the gear. Tighten the tube nut (3) to 32 Nm (24 ft. lbs.).
14. Install the return hose tube (1) at the gear. Tighten the tube nut (2) to 32 Nm (24 ft. lbs.).
