Journey FWD V6-3.5L (2009)
8. Release the lower ball joint (5) from the lower control arm (1) using Remover (2) 9360. Do not lift the knuckle out of the lower control arm at this
time.
9. Lift the knuckle (2) out of the lower control arm (5).
NOTE: Do not allow the half shaft (1) to hang by the inner C/V joint; it must be supported to keep the joint from separating during this
operation.
10. Pull the knuckle (2) off the axle half shaft (1) outer C/V joint splines and support the half shaft.
11. Through the access hole (1) in the knuckle, tap the ends of the snap-ring (2) with a drift punch and remove it from the ball joint.
