Journey FWD V6-3.5L (2009)
4. Slide the hub and bearing in the knuckle (2) onto the splines of the half shaft outer C/V joint (1).
5. Insert the lower ball joint stud into the mounting hole in the lower control arm.
6. Install a NEW ball joint stud nut (4). Tighten the nut to 95 Nm (70 ft. lbs.).
CAUTION: The strut clevis-to-knuckle bolts (5) are serrated and must not be turned during installation. Install the nuts while holding the
bolts stationary in the steering knuckle. Refer to the following step.
7. Position the lower end of the strut assembly (3) in line with the upper end of the knuckle (6), aligning the mounting holes. Install the two mounting
bolts (5).
8. Install the nuts (2) on the two bolts (5). While holding the bolts in place, tighten the nuts to 140 Nm (103 ft. lbs.).
