Journey FWD V6-3.5L (2009)
5. Remove the clamp (if installed) from the bottom of the coil spring and remove the strut (damper) (9) out through the bottom of the coil spring.
6. Remove the lower spring isolator (8) from the strut seat.
7. remove the dust shield (5) and jounce bumper (6).
8. Remove the upper strut mount (2) from the top of the bearing and upper spring seat (3).
9. Remove the upper spring seat (3) and isolator (4) from the top of the coil spring (5).
NOTE: If the coil spring needs to be serviced, proceed with the next step, otherwise, proceed with 11.
10. Release the tension from the coil spring by backing off the compressor drive completely. Push back the compressor hooks and remove the coil
spring.
11. Inspect the strut assembly components for the following and replace as necessary:
-
Inspect the strut (damper) (9) for shaft binding over the full stroke of the shaft.
-
Inspect the jounce bumper (6) for cracks and signs of deterioration.
-
Inspect the dust shield (5) for cracks and tears.
-
Check the upper mount (2) for cracks and distortion and its retaining studs for any sign of damage.
-
Check the bearing and upper spring seat (3) for any binding.
-
Inspect the upper and lower spring isolators (4, 8) for material deterioration and distortion.
-
Inspect the coil spring (7) for any sign of damage to the coating.
NOTE: For reassembly, See: Front Suspension Strut Assembly - Assembly .
Front Suspension Strut Assembly - Assembly
ASSEMBLY
NOTE: If the coil spring has been removed from the spring compressor, proceed with the next step, otherwise, proceed with 3.
NOTE: To determine the flat coil end of the coil spring for the following step, attempt to stand the coil spring on-end on a flat, level surface. If
