Journey FWD V6-3.5L (2009)
1. If removed, install the quick connect fitting into the transmission oil cooler or the transmission. Tighten the fitting to 15 Nm (132 in. lbs.).
2. Align the cooler line (3) with the quick connect fitting while pushing straight into the fitting.
3. Push in on the transmission cooler line until a click is heard or felt.
4. Slide the dust cap (4) down the transmission cooler line and snap it over the quick connect fitting until it is fully seated and rotates freely. The dust
cap will only snap over the quick connect fitting when the transmission cooler line is properly installed.
NOTE: If the dust cap will not snap into place, repeat step 2.
