Removal of Quarter Glass for Journey FWD V6-35L (2009)
2. Bead dimensions should be approximately 9.5 mm wide (1) by 12.7 mm in height (2).
3. Allow end of adhesive bead (1) to run out parallel to the start of the bead and smooth ends flush.
4. Lift quarter glass into place in the center of the quarter glass opening and install over the alignment tabs and pin.
5. Carefully lay down the quarter glass and press on.
CAUTION: It is no longer possible to move the quarter glass after installation. The quarter glass should never be pressed into place by more
than one person, because the quarter glass can break if pressed simultaneously on both sides.
CAUTION: Roll down the left and right front door glass and open the rear glass slider (if available) before installing quarter glass to avoid
pressurizing the passenger compartment if a door is slammed before urethane is cured. Water leaks can result.
6. Install quarter panel trim. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage Compartment Trim/Quarter
Trim Panel - Installation
