Journey FWD V6-3.5L (2009)
The unibody hose (3) exits the body wire harness near the top of the D-pillar, where it is connected to the liftgate washer hose (2) by a quick connect
fitting. The liftgate washer hose is routed up the D-pillar to the upper liftgate opening header panel, then to the center of the upper liftgate opening. The
liftgate hose is routed through a hole with a rubber grommet in the upper liftgate opening header panel and passes through another hole with a rubber
grommet in the upper liftgate panel (1) to the rear washer nozzle on the upper liftgate.
Washer hose is available for service as roll stock, which may be cut to length. The unibody washer hose is integral to the body wire harness. The molded
plastic washer hose fittings and routing clips cannot be repaired. If these fittings or clips are ineffective or damaged, they must be replaced.
