Journey FWD V6-3.5L (2009)
1. Using a trim stick or another suitable wide flat-bladed tool, gently pry the rear washer nozzle (3) to release the latch features that secure it in the
mounting hole of the liftgate outer panel (1).
2. Pull the rear washer nozzle out from the liftgate outer panel far enough to access the washer supply hose (2).
3. Disconnect the hose from the barbed nipple on the back of the nozzle.
4. Cut 4 to 6 millimeters (0.15 to 0.23 inch) from the end of the hose to ensure a good fit to the barbed nipple of the replacement rear washer nozzle.
5. Discard the removed nozzle.