Journey FWD V6-3.5L (2009)
1. The rear wiper arm (1) must be indexed to the rear wiper motor output shaft with the motor in the park position to be properly installed. Position
the wiper arm pivot end onto the output shaft (3) so that the tip of the wiper blade is aligned with the second rear window defogger grid line from
the bottom of the liftgate glass.
2. With the rear wiper arm properly indexed, push the tapered mounting hole on the pivot end of the wiper arm down over the output shaft.
3. Install and tighten the nut (4) that secures the rear wiper arm to the output shaft. Tighten the nut to 9 Nm (80 in. lbs.).
4. Fold and snap the molded plastic nut cover (2) over the nut on the pivot end of the rear wiper arm.
5. Wet the lift glass and operate the rear wiper. Turn the rear wiper switch to the OFF position, then check for correct wiper arm position and readjust
as required.
